Tel: 07947523270

266 Swinnow Lane Leeds LS13 4HP uk


–Direct control of 3 retract motors. Independently programmable delay for each gear in both UP and DOWN sequence.

–Control of electronic brake. fully proportional, linear or adjustable pulsing mode (ABS). Brake Limiter also available to set  the maximum brake force

–3 servo outputs for the control of gear doors. Endpoints are individually programmable, each output can be programmed in 3 different positions (Gear UP, Gear Down and Gear Moving phase).

Servo Switch-off. Door servos can be deactivated after movement to prevent the posibility of servo burnout on a jammed door. Deactivation time can be programmed.

–Steering servo processor. Programmable position in retracted mode, programmable center, sense and travel once retracts are extended.

–Single or dual channel mode. Gear and brakes can be combined on single channel or use separate channels .

–Manual mode. Provides the ability cycle the gear manually for testing during setup phase, movement can be stopped and reasumed in any position.

Each drive motor can be independently run in any direction and stopping in any position for checking clearance, etc.

–Easy programming trough the LCD display. All adjustments are done through an Electron programmer. Compatible with all Xicoy SBus style data terminals used with Xicoy brand ECU’s.

RS200 can also be programmed by LED/Button like RB-45 (options limited using this program method).

Battery Acording to the retract model: up to 13V for ER-30 and ER-40, and up to 10V for ER-50

Box measures: 55x30x15

Weight: 25gr

RS200 Controller