266 Swinnow Lane Leeds LS13 4HP uk
Programming Gear and Brakes
Step #1 Upon receiving your unit, connect all three of the gear legs. Next connect the inputs from your RX to your RB-45, Gear Inputs, Brakes (if applicable) Rudder Servo and Rudder Input (steering servo).
Step#2 Now you must solder your power leads to a multiplex connector. You will notice there are three pins for the POS and NEG. It is recommened that you use the three pins for each lead. ( Better load distribation), CHEKING THE POLARITY TWICE following the label indications
Step#3 With your TX ON, hold the led button down and now turn on the power to your RX, and now release the led button. You will now get a single flash which indicates the start of the programming mode.
Step#4 Put the radio in the gear up position and repress the led button. You will now see two flashes on led.
Step#5 Put radio in the gear down position, and repress led button. You will see three flashes and this will be start of brake programming.
Step#6 Put the radio switch for brakes in the O% position and press the led button. You will now see four flashes.
Step#7 Put the radio switch for brakes in the 100% position and press led button again. You will see five flashes, ( configuration for rudder servo set up)
NOTE. If you do not have brakes, just press the led button twice to skip the brakes calibration. You will see five flashes and now, press the led and this will set the steering servo position and complete the programming.Type your paragraph here.
Control: 3 retracts, steering servo, and brakes (proportional braking)
Box measures: 55x30x15
Battery according to the retract model: up to 13V for ER-30 and ER-40, and up to 10V for ER-50
Copyright © Jettstreamuk
Pictures are for illustration purposes only. All brand names and trademarks are acknowledged. E&OE.